Know your system. Operator and service manuals.

You’ll get the most our of your Cirus Control system by performing correct operations and regular maintenance. An operator and service manual is standard with every electronic spreader control, proportional plow control, hydraulic system and data management system.

Operator and service manuals:

• Electronic spreader controls
  • SpreadSmart Rx Touch™
  • SpreadSmart Rx™
  • SpreadSmart Rx™ with Mini Tiger™
  • SpreadSmart Rx Touch™ with Tiger Shark™ (2007 and older)
  • Dual Spread™
  • EZ Spread™
• Proportional plow controls
  • Uni-Grip™ Series - Mako I, Mako II
  • Multi-Stix™ Series - Mako I, Mako II
  • Black Tip™ Series
  • Lamprey™ Series
  • Manual power float valve
  • Automatic power float valve
• Hydraulics
  • Open circuit piston pumps
  • Sauer Danfoss PVG 32 Air
  • Sauer Danfoss PVG 32 Electric
  • Sauer Danfoss PVG 32 Manual
  • Modular manifold systems
  • Quick coupler drain manifolds
• Telematics
  • Drive-by Download™
  • Data Analysis Tool™
  • SiteMarker D™
• Accessories
  • HammerHead™ 12-Switch Accessory Control
  • Hydraulic pre-wet power modules
  • Electric pre-wet power modules
• AVL Technical Notes
  • 06-005 AVL output verification
• Cables Technical Notes
  • Diagnostics of sensors using LED’s in junction box
• Drive-by Download™ Technical Notes
  • 07-002 IP addresses for Drive-by Download™
  • Driveby Wireless Device Manual (Quatech Bridge & DLINK AP) Rev C
• Hydraulic Valve Technical Notes
  • 08-007 Hydraulic release under pressure no power procedure
  • 09-013 Converting LS PVG PB plumbing
  • 10-006.1 Convert manifold between open center and load sense
  • 10-007 Adding pre-wet components to Cirus manifold
  • 11-004 Field convert PVG32 from DA to SA
  • 11-007 Hydra Force E coils assessment
  • 11-009 Spreader block conversion parts
  • 11-011 Convert PVG hybrid inlet spreader between load sense and open center
• Mako™ Technical Notes
  • 06-001 Joystick plug warning for field install
• Pre-Wet Power Modules Technical Notes
  • 11-003 Set & calibrate open loop pre-wet pump system
• Sensor and Flow Meter Technical Notes
  • 08-009 Validation of flow meter rating
  • 08-010 Validation of auger sensor function
• SpreadSmart Rx™ Technical Notes
  • 05.001 SpreadSmart Rx™ & Dual Spread™ backup battery
  • 08-011 Using SpreadSmart Rx™ pre-wet channel for gravity feed pre-wet
  • 09-001 Pre-wet in gallons per mile
  • 09-004 SpreadSmart Rx™ manual mode for accessory hydraulic circuits
  • 09-015 Temp response setup and operation
  • 09-016 Using AI channel to control pre-wet
  • 10-002 AI power module with TS-800X
  • 10-008. Configure SpreadSmart Rx™ for hydraulic pressure on display
  • 10-011 Shared control of single valve section _PW & AI_
  • 11-006 Granular drop test closed and open loop
  • 11-008 Roadwatch connectors & compatability 5-11

Contact us for more information on operator and service manuals for Cirus Controls products.